Add:PANGCUN INDUSTRIAL ZONG,YINBIN DISTRICT,LUOYANG,HENAN 453621 P.R. CHINA
Steel filing cabinet assembly method
Author: lyaijinuoTime: 2018-07-02 09:30:29
1. First, lay the back plate on the floor, then insert the left and right side plates into the back plate, and fix them with screws.
2. Place the grouped cabinets on the floor, put the door panel frame into the left and right side panels of the cabinet, and pull the panel out by hand until it is flush with the front panel of the side panel.
3, open the door, put the bottom plate into the lower part of the cabinet space, the three single side of the bottom plate into the inside of the cabinet and the back panel on the card strip, down flat.
4. Place the middle board into the space of the cabinet beforehand, then place the upper cover up from the bottom up to the top of the cabinet, and fix it with screws before and after.
5. Place the preliminarily-placed mid-sized board from the left to the right and snap it into the card cover strips of the upper cover and the bottom board.
6. Insert the grid panels into the card joints in the left and right spaces of the cabinet, insert the clothes hangers into the mounting brackets, and finally check the installation locations. After confirming the installation positions, the assembly is completed.
Only six steps are needed to complete the assembly of steel filing cabinets. However, when assembling, pay attention to the number of the parts and the up, down, left, and right sides. Pay attention to the order of the positions. Otherwise, the assembly cannot be performed.